Apollo x8p - sound gone when I open DAW

[Grillparzer]

Hi!
I have the following problem: I turn on my Apollo x8p and it connects to my Macbook Pro M1, I plug in a guitar in Hi-Z 1. I see an input signal in Console. I can hear the incoming audio in Console. Then I turn on Logic (or Luna). Relay clicks once in the Apollo. Then the signal is gone - in Luna/Logic and in console. The meters aren't moving. The software is "alive" though, cause when I unplug the guitar from HI Z, it switches back to Line. I can get the sound back, if I unplug and re-plug the data cable. But the sound is muffled and quieter.
What's happening?

What I've done so far:
Completely set up the Macbook anew, getting rid of all presets, drivers etc. in the process
Reinstalled every application in the process
Did a hardware reset

Any suggestions?

 

[hotspot]

What's happening?

What sample rate are you reading in the console and in Logic?
Sample rate in Luna should automatically match with the console, but not in Logic. There you have to set it in the project settings.

 

[Grillparzer]

88,2. I switched now to 48khz now and the problem is gone. Was very strange though.