Del-Vibe Loud Sound When Switching Models
- Thread starter ArminSZ
- Start date
Also have it with my del-verb. Yes, bugs and issues are very normal with UAFX pedals.
I tried different power supply’s - all the same.
Yes, maybe a software-bug - but I updated to the latest version.
I have to try if switching off the effect during the model-switch will help.
Yeap, definitely no power supply issue. If you still get pop noises when the effect is turned off than this is another major software bug in UAFX pedals. Will try this as well.
Last edited:
Imho it’s a very severe bug.
It’ not possible to switch models without being afraid to hear a very loud “pop” from time to time.
Today I investigated a little bit further - it happens even when delay and reverb foot switches are off.
When I set reverb type to “Hall 224” before I connect DelVerb to power - than power it on - as soon as I switch to “Spring 65” there is a very loud “pop”.
no, just the DelVibe in the loop
LesBrown
Hall of Fame Member
Aside from the app, I haven't seen a bug or issue with my Ruby, Lion, Dream or Ox Stomp. But, maybe I'm just not normal.
Missing speaker drive knob and buggy reverb in ox stomp -> your share of UAFX bugs. Other than that the bugs I discovered or was affected by were happening in Astra, Starlight, Golden (Huge Volume Jump after Firmware update 1.1.7), Del-Verb (pop noise when switching algos, voicings gone and app broken after UAFX control update), Galaxy 74 (doesn’t remember secondary knob settings after restart). So I think you are just lucky with the selection of UAFX pedals you purchasedAside from the app, I haven't seen a bug or issue with my Ruby, Lion, Dream or Ox Stomp. But, maybe I'm just not normal.
Del-Verb is always buffered bypass (same for galaxy 74, max, dream, ruby, lion, woodrow, ox stomp).
klasaine
Hall of Fame Member
Me too.I think you are just lucky with the selection of UAFX pedals you purchased
Starlight, Del Verb, all four amp pedals and the 1176 comp small format box.
Zero issues with the physical pedals and since that last uafx control update - no problems with the app. Both Android and iOS.
PRS - tube buffered
Yes, I tried another power supply (rated 1A), and put it in front of another battery powered amp.
All the same.
If both switches are in the lowest position before powering on - and than putting the right (reverb) switch in the upmost position (spring) - there is this “pop”.
Usually only the first two times after powering on / than all is fine most of the time / but happens once in a while with both switches (delay and reverb time).
All the same.
If both switches are in the lowest position before powering on - and than putting the right (reverb) switch in the upmost position (spring) - there is this “pop”.
Usually only the first two times after powering on / than all is fine most of the time / but happens once in a while with both switches (delay and reverb time).
Exactly the same thing is going on with my Del-Verb. Doesn’t have anything to do with periphery, is definitely a bug of the pedal itself.