Hello,
A computer guy convinced me that instead of letting my computer go to sleep, and or actually turning it off,.. that it was much better to put the computer in \"stand by\" mode when it's not in use.
The problem is that when I \"wake up\" the computer, my software(Cubase Sx and Wavelab) doesn't recognize the card and I get an error message. I then have to re boot and the card is then recognized and functions fine.
Any other solutions to the \"stand by\" mode delimma?
Thanks,
Marc
A computer guy convinced me that instead of letting my computer go to sleep, and or actually turning it off,.. that it was much better to put the computer in \"stand by\" mode when it's not in use.
The problem is that when I \"wake up\" the computer, my software(Cubase Sx and Wavelab) doesn't recognize the card and I get an error message. I then have to re boot and the card is then recognized and functions fine.
Any other solutions to the \"stand by\" mode delimma?
Thanks,
Marc