Hi!
I just updated my computer to MacBook Pro M3 Max (with Sonoma 14.1.1). I'm having this problem where I'm either not being able to connect my Apollo to my computer or the connection drops suddenly. I have installed the software according to your instructions (the Recovery Mode settings and allowing the UAD on System Settings' Security section). I even uninstalled it once (following your instructions) and reinstalled it. When I first opened the UAD Meter & Control Panel (UAD M&CP) often installing the software and connected the Apollo and switched it on, it worked just fine. The Console also worked fine and I could use all of my UAD Plug-ins in my DAW (Ableton). When I switched my Apollo off, it disappeared from UAD M&CP just fine. After that, when I switch the Apollo back on, the UAD M&CP won't detect it. It just says "Connect UA Device". I've tried to first launch UAD M&CP and then switch on the Apollo (doesn't work), first switch on the Apollo and then launch UAD M&CP (doesn't work). I've tried to connect it to a different port on my Mac (won't help). If I switch off the Apollo and let it rest for five minutes before switching it back on, the UAD M&CP detects it and it works just fine. Do anyone else have similar problems with M3 Mac of other Silicon Macs or macOS Sonoma? My Apollo connects just fine to my old Mid-2015 MacBook Pro.
Best Regards,
Janne
I just updated my computer to MacBook Pro M3 Max (with Sonoma 14.1.1). I'm having this problem where I'm either not being able to connect my Apollo to my computer or the connection drops suddenly. I have installed the software according to your instructions (the Recovery Mode settings and allowing the UAD on System Settings' Security section). I even uninstalled it once (following your instructions) and reinstalled it. When I first opened the UAD Meter & Control Panel (UAD M&CP) often installing the software and connected the Apollo and switched it on, it worked just fine. The Console also worked fine and I could use all of my UAD Plug-ins in my DAW (Ableton). When I switched my Apollo off, it disappeared from UAD M&CP just fine. After that, when I switch the Apollo back on, the UAD M&CP won't detect it. It just says "Connect UA Device". I've tried to first launch UAD M&CP and then switch on the Apollo (doesn't work), first switch on the Apollo and then launch UAD M&CP (doesn't work). I've tried to connect it to a different port on my Mac (won't help). If I switch off the Apollo and let it rest for five minutes before switching it back on, the UAD M&CP detects it and it works just fine. Do anyone else have similar problems with M3 Mac of other Silicon Macs or macOS Sonoma? My Apollo connects just fine to my old Mid-2015 MacBook Pro.
Best Regards,
Janne