Wave being truncated in Wavelab

[the lewis bros.]

I just bought a new card (LynxTWO) and I'm not sure if the problem is the card, or Wavelab 5, or the new UAD plugs/driver.

When rendering in Wavelab 5, with the Precision Limiter, and Precision Multiband as the only plugs in the master section, the start of the wave is truncated.

Anyone else see anything like this?

 

[andia]

it's the same here!

a workaround: insert 2-3sec silence at the beginning and you should be fine!

 

[Akis]

I think this happens because of the lack of plug-in delay compensation in Wavelab.

 

[the lewis bros.]

Thanks for your replies. It didn't happen until I installed the new sound card (or maybe I didn't notice it?)
Anyway, over on the wavelab forum, there is hope that this is fixed in Wavelab 6.
I did insert silence, but not enough I guess.
So 2-3 secs for rendering with UAD plugs, then trim again...not too practical if you are editing a wave from Cubase for instance, where you don't want to move the start point.